Just check the Lightburn doesnt alter the $32 setting for you when it runs, if it does, set it back to /0 for CNC mode (See gnea/grbl and a longer explanation here: gnea/grbl )
If you have your spindle under software control:
Have a full read through the Grbl Wiki /gnea/grbl/wiki to understand how it all works So if you change a setting in CONTROL, and later check the setting in Lightburn, its reading it off that eeprom. Its not stored in control, and not in Lightburn either. Grbl settings are only stored on the EEPROM memory inside the microcontroller on your board.
0 kommentar(er)
